XChange1002

Dual PrPMC cPCI Carrier Card with PICMG 2.16 Switched Ethernet

The XChange1002 is a versatile 6U CompactPCI dual PMC carrier card with a PICMG 2.16 Gigabit Ethernet backplane interface. It supports 100 MHz PCI-X on both the CompactPCI and local bus interfaces.

End of Life

Please see recommended replacement product, the XChange1200 Dual PrPMC cPCI Carrier Card.

Learn more about this product below »
REQUEST A QUOTE ASK A QUESTION

Contact us directly at +1 (608) 833-1155

SKU: 90050065 Category:
XChange1002 cPCI Carrier Card

The XChange1002 is a versatile 6U CompactPCI dual PMC carrier card with a PICMG 2.16 Gigabit Ethernet backplane interface. The XChange1002 supports 100 MHz PCI-X on both the CompactPCI and local bus interfaces (the XChange1002 uses a transparent bridge, which allows it to operate as a peripheral carrier card in a CompactPCI environment).

PICMG 2.1 Hot Swap support allows the XChange1002 to be installed into a live system without disrupting CompactPCI bus activity. In addition, the system management bus support allows the card to be powered down and reset remotely through the PICMG 2.9 IPMI interface. The IPMI interface also allows for the monitoring of voltage and temperature levels on the cards attached to the two PrPMC slots.

Features

  • 100 MHz PCI-X cPCI and local bus interfaces
  • Hot Swap support
  • Two PICMG 2.16 backplane Ethernet ports
  • Complies to PICMG 2.0, 2.1, 2.3, 2.9, and 2.16
  • IPMI satellite management controller
  • Wind River VxWorks BSP
  • Linux BSP

Technical Specs

cPCI

  • PICMG 2.1 (Hot Swap support)
  • PICMG 2.3 (PMC I/O to J3 and J5)
  • PICMG 2.9 (dedicated IPMI controller)
  • PICMG 2.16 (two 10/100/1000BASE-T Ethernet ports)

PCI-X PMC Slots

  • Maximum aggregate bandwidth of 1 Gb/s
  • Processor PMC (PrPMC) support

Software Support

  • Linux BSP
  • Wind River VxWorks BSP
  • IPMI drivers

Physical

  • 6U cPCI form factor
  • 233.35 mm x 160 mm

Environmental Requirements

Contact factory for appropriate board configuration based on environmental requirements.

  • Supported ruggedization levels (see the X-ES Ruggedization Chart): 1
  • Conformal coating available as an ordering option

Power Requirements

  • 3.3 V, 0.61 A, 2 W

Accessories

Please contact X-ES Sales at sales@xes-inc.com or by phone at +1-608-833-1155 for information on this product's accessories.

Documentation

Datasheet

To view all of the information about this product in a PDF, please download the datasheet.

Download Datasheet

Technical Documents

SupportNet is your source for product manuals, technical support, and software downloads.

Access SupportNet

Block Diagram

Additional Information

Replacement Product

View the recommended replacement product, XChange1200

View Product

Datasheet

View the XChange1002
Datasheet PDF
 

Download Datasheet
Back to Top
Fast, Flexible, and Customer-Focused Embedded Solutions
© 2018 Extreme Engineering Solutions, Inc