The XChange3030 is a conduction-cooled 3U VPX Ethernet switch module. The XChange3030 provides six backplane 40GBASE-KR4 Ethernet ports, six backplane 10GBASE-KR Ethernet ports, two backplane 10GBASE-T Ethernet ports, and one front panel optical Ethernet port.
The XChange3030 delivers full wire-speed across all of its ports and supports jumbo frames up to 10 kB. It also supports IPv6 and a comprehensive set of IETF RFCs and IEEE protocols.
As a fully managed Layer 2 switch, the XChange3030 supports features such as VLANs (IEEE 802.1Q), LACP, STP, RSTP, PVRST, MSTP, SNMP, flow control, port mirroring, port authentication (IEEE 802.1x), Quality of Service (QoS), ACL, IGMP, and LLDP.
The XChange3030 can also optionally host an XChange6300 Cisco IOS-XE® Gigabit Ethernet Embedded Services Router. The XChange3030 is SOSA-aligned to AMPS profile MODA3-16.4.16-1-F2C-(E8/E7)-(6E7-E3)<N-N-N-N>, although limitations apply. Contact factory for details and other supported AMPS profiles.
Technical Specs
Ethernet
- Six 40GBASE-KR4 Ethernet ports (can be configured as 24 10GBASE-KR)
- Six 10GBASE-KR Ethernet ports
- Two 10GBASE-T Ethernet ports
- One front panel optical Ethernet port
- IPv4 and IPv6 support
- Support for jumbo frames up to 10 kB
- Non-blocking, full wire-speed
- IEEE 1588v2 transparent clocking support
Ethernet Management Features
- Layer 2 switching (including VLANs)
- Extensive IEEE protocol and IETF RFC support
- Configuration through CLI or SNMP
- 4 MB packet buffer
XMC (Optional)
- One XMC site (available on configurations with integrated mezzanine card)
- One RS-232 serial port from J16 to P1
- One 2500BASE-X Ethernet port, and two 1000BASE-X Ethernet ports from J16 connect to XChange3030 when paired with XChange6300 Embedded Services Router
Additional Features
- VITA 46.11 Tier 1 and Tier 2 IPMI Controller (IPMC)
Physical Characteristics
- 3U VPX form factor
- SOSA-aligned to AMPS profile MODA3-16.4.16-1-F2C-(E8/E7)-(6E7-E3)<N-N-N-N> (I/O limitations apply, contact factory for details and other supported AMPS profiles)
- Dimensions: 100 mm x 160 mm
- 0.8 in. or 1.0 in. pitch
- Compliant to the VITA 48.2 Type 1, Two-Level Maintenance (2LM) standard (optional, contact X-ES for details)
Environmental Requirements
Contact factory for appropriate board configuration based on environmental requirements.
Power Requirements
- Power will vary based on configuration and usage. Please consult factory.
Documentation
Datasheet
To view all of the information about this product in a PDF, please download the datasheet.
Download Datasheet
Technical Documents
SupportNet is your source for product manuals, technical support, and software downloads.
Access SupportNet
