XChange3001

The XChange3001 is a 3U VPX-REDI carrier module supporting a single-width XMC card. It provides an easy way to integrate switched mezzanine cards into modern VPX backplanes.

The XChange3001 supports a generic x8 interface on the VPX fabric connector, allowing a variety of high-speed protocols to be used. It also supports VITA 46.9 X12d+X8d+X24s I/O routing on P2, with the option to extend XMC routing to P1.

Features

• 3U VPX-REDI carrier card
• Conduction cooling
• Generic x8 XMC interface
• X12d+X8d+X24s I/O routing per VITA 46.9
• No drivers needed

Technical Specs

VPX

• Generic x8 interface supporting a variety of protocols

XMC

• Generic x8 interface
• VITA 46.9 X12d+X8d+X24s I/O routing on P2, with option to extend routing to P1

Physical Characteristics

• 3U VPX form factor
• Dimensions: 100 mm x 160 mm, 10 mm stacking height

Power Requirements

Power will vary based on configuration and usage. Please consult factory.

Environmental Requirements

Contact factory for appropriate board configuration based on environmental requirements.

• Supported ruggedization levels (see the X-ES Ruggedization Chart): 5
• Conformal coating available as an ordering option

Accessories

• XIt1074 (90060270) - 3U VPX Rear Transition Module with XIM/PIM Carrier
• XPedite5205 (90010225) - Embedded Services Router (ESR) with Cisco IOS® on an XMC/PMC Module

Documentation

Datasheet

To view all of the information about this product in a PDF, please download the datasheet.

Download Datasheet

Technical Documents

SupportNet is your source for product manuals, technical support, and software downloads.

Access SupportNet